Strona główna  |  Zastrzeżenie
O Firmie Obróbka cieplna Spalanie Publikacje Nowości Kontakt
Deutsch        English        Français     
Procesy / Zasilanie
Ponowne nagrzewanie stali
Przemysł energetyczny/ Energetyka
Przemysł petrochemiczny i rafineryjny
Szkło/Ceramika
Spopielanie
Sondy tlenowe
Oprzyrządowanie
  Przemysł energetyczny/ Energetyka -
KONTROLA PROCESU SPALANIA

Polska wersja jest w trakcie przygotowania
 

 


OxyFire Sensors: Typically used in a coal-fired power boiler, the high temperature, in-situ oxygen sensor is generally installed in the boiler water-wall, above the nose arch and above each of the burner banks. This configuration allows the boiler operators to center the fireball in the radiant zone and "balance" the boiler.

Typically installed above the slag line, the sensors give the boiler operators a unique perspective on the combustion process, eliminating the typical "air infiltration" that confuses "low temperature" sensors located in the back pass.

Benefits from using Marathon Monitors' Combustion Optimization System to "trim" the draft are:

  • Balanced boiler - Centering the fireball

  • Minimizing NOx formation

  • Reduces over-all maintenance costs
Providing the operators with this type of information allows them to do their job more efficiently, eliminates CO (carbon monoxide) pockets, and helps in achieving "lowest cost" megawatts.

Oxygen Sensors: Oxyfire High-Temperature Series     LOROX Low-Range Temperature Series

LOROX Sensors: Typically used in fossil fuel fired power boilers where the slag line is very high. These sensors are often installed in the back pass section where temperatures are too low for Oxyfire sensors to operate. Response time is still very fast and the LOROX is easily maintained without removal.

Instruments: VersaPro - Oxygen Setpoint Controller / Monitor


Application Bulletin                     Installation

 

DO GÓRY      POWRÓT