FAQ's about our heat treating products; oxygen & carbon sensors, temperature
control devices, and probe instruments for the heat treating industry.
How do I use Temperature / Carbon Deviation Alarms in a recipe?
How do I send a set point change to a slave instrument using a recipe on
a Dualpro or Multipro?
What happens when I run a probe care sequence?
How do I verify that my instrument is OPC upgradeable?
What is the calibration procedure for the Multipro?
How do Limit and Alarm Statements work in Version 3.5 Recipes?
How do I upgrade the firmware on a Dualpro / Multipro CPU board?
How do I program the Dualpro Analog Inputs?
How do I setup the Dualpro to measure percent oxygen?
What is the Dualpro Calibration Procedure?
How do I determine dew point from my probe temperature and millivolt
How do I use the instrument clock and counters in a recipe?
How do I write a recipe for a Marathon Monitors instrument?
How do I troubleshoot a carbon probe?
How can I determine carbon from my probe temperature and millivolt
How do I calibrate the probe mV input on an AACC 2000 series instrument?